Ricerca Scientifica

BONE DENSITY AND IMPLANT PRIMARY STABILITY. A STUDY ON EQUINE BONE BLOCKS

2019
Autore : Orlando F., Di Stefano D.A.

An innovative biomechanical study shows that an equine-enzymatically deantigenated bone block is similar to a human cancellous bone

Previous results on synthetic blocks mimicking bone indicate that bone density can be measured by the friction encountered by a rotating probe while it descends into bone, and that primary implant stability may be measured through the integral (I) of the torque-depth curve at implant insertion. This study aims to repeat those tests on collagen-preserving equine bone blocks as they better reproduce the mechanical properties of natural bone. Fifteen cancellous equine blocks had their density measured using a measuring probe. This was compared to their known physical density through linear regression analysis. Implant placement was carried out into six cancellous equine blocks and primary stability was measured using (I), as well as the insertion torque (IT), the implant stability quotient (ISQ), and the reverse torque (RT). The relation between (I), (IT), (ISQ), and (RT) was investigated by correlation analysis. Bone density measured using the probe correlated significantly with actual density, both with (r = 0.764) and without irrigation (r = 0.977). (I) correlated significantly with IT and RT under all irrigation conditions, and with ISQ only without irrigation (r = 0.886). The results suggest that the probe provides actual bone density measurements. They also indicate that (I) measures primary implant stability and is more sensitive to density variations than IT, RT, and ISQ. Results are consistent with those obtained on synthetic blocks but suggest that equine bone blocks may better reproduce the mechanical properties of human cancellous alveolar bone. This should be the subject of additional studies.

PRODUCTS USED: Osteoplant bone block, OSP-01C, OSP-01E

Dent J
Logo Bioteck Academy


Vicenza
Sede Amministrativa e legale
via E. Fermi, 49
36057 Arcugnano, Vicenza (VI) - Italia
Tel. +39 0444 289366
Fax: +39 0444 285272


Contattaci


Torino
Centro Polifunzionale di produzione
Via G. Agnelli, 3
10020 Riva presso Chieri, Torino (TO) - Italia

Copyright © 2020 Bioteck S.p.A. - Privacy Policy - Cookie Policy